ICRealtime How-to Notes 96005

 

Motion Detection Setup [DVR FLEX4/8/16]

 

 

[This note applies to all ICR Flex series DVRs]

Note: In the picture, the number represents the step number in the walkthrough.

 

            Step 1: Power up the system and wait till its done booting.

                  

Step 2: Login to the main menu from your system by pressing “Enter” or “Menu” on the unit’s key pad. Default Admin users include: “888888” and “admin”. The passwords for these users are the exact same as the user    names are spelled

           

Step 3: While at the main menu, highlight and press enter on the “Config” icon. Now click on the “Record” button.

 

Step 4: While in the “Record” menu you have to select each channel for which you want to setup motion detection (MD) on. To select all channels for MD, choose “ALL” in the drop down box. Now choose which day of the week you want MD to be active. To select everyday of the week, choose “ALL”. Now under record type select the record times that you want MD to be active at. If you want it be on all hours of the day, be sure “Period 1” is set from 00:00 to 24:00 and the MD check box is highlighted. Make sure when you have the MD box highlighted, the regular and alarm box aren’t highlighted since this will cause a conflict in your recording. Once everything is done the way you want it, navigate down to save and press enter.

 

 

 

           

Step 5: You should now be back in to the “Config” menu. Highlight and select the “DETECT” icon.

 

Step 6: In this menu you can select the type of recording on each channel, select the region on which the MD is active at, change the sensitivity of the MD and various smaller details pertaining to MD and alarm settings.

           

Step 7: First select a channel to begin with the settings (again you can select “ALL” to choose all the channels for the same settings). Now go down and select the “Region” select button. Here you can choose specifically where you want the channel to watch for motion. You can un-highlight each cube on the screen to have it not look for motion in that spot. To highlight or un-highlight a specific spot on the region, press the “F1” key on your DVR. If you leave the region as is, it will look for motion across the whole screen.

 

Step 8: Next you can select the sensitivity of how cameras react to detecting motion in your region. The higher the number, the more sensitive it is. You will have to change the sensitivity if for some reason the motion is not being detected by the camera.