ICRealtime How-to Notes 96051

 

Video Balun/UTP Transceivers/Receivers Quick Install Guide

 

[This note applies to all ICR Flex series DVRs]

 

Step 1: Make sure to turn off power on all CCTV equipment that you will be using with the video baluns.

 

Step 2: Be assured that all UTP (unshielded twisted pair) cabling in which you will be running for the cameras are all marked for which camera you will be using it for so that you do not cross connect any existing runs. Labeling individual runs will help organize the install.

 

Notice: If utilizing data ports (or switches) for your run(s), be sure not to confuse devices belonging to the other end of that port. Using video baluns with un-approved devices could result in damage of the foreign device or video balun.

              

Step 3: Video baluns operate in pairs of wires so be sure to read the video balun’s instructions on which wires are paired from your UTP cabling.

 

 

Step 4: Depending on the equipment being connected, connect the BNC connector of the video balun to the coax connector or cable on the video equipment at each end of the link.

 

 

 

Step 5: Confirm the pin configuration of the video balun and the UTP cable run once again.

 

Step 6: Connect one end of a UTP cable run to the RJ45 modular jack of the video balun.

 

Step 7: Plug the other end of the cable run into the appropriate data port (switch) or directly in to the other end of the other video balun.

 

Step 8: Power up all device involved in the installation and be assured you have proper video coming from the camera(s).